Classifieds

Page 10 of 10 FirstFirst 12345678910
Results 136 to 138 of 138
  1. #136
    Ausfish Bronze Member
    Join Date
    Apr 2014
    Location
    Brisbane
    Thread Starter

    Re: Mustang 24 rebuild

    Finished the locker floor repair.
    IMG_4136.jpg IMG_4145.jpg

    The top was epoxied down, glassed to the hull with epoxy on top, and a 25mm epoxy glue cove underneath.

    Now I'm happy.

    Just need to sort out the problem of the burst water tank, then get onto a bit of upholstering...

  2. #137
    Ausfish Bronze Member
    Join Date
    Apr 2014
    Location
    Brisbane
    Thread Starter

    Re: Mustang 24 rebuild

    You may recall the the Mustang has been put seriously onto the back-burner over the past few months, with my obsessing over the HH 1600 SO ski boat and the refurbishment of the Ventura.

    I'm very pleased to say that I'm back onto the Mustang.

    Obviously from the past couple of updates, the 300 Suzi has been removed, converted from an XXL to an XL and refitted after the pod was modified.
    The damage caused by my slackness and the anchor winch has been repaired and future proofed, and the trailer adjustment will be happening soon...

    But the biggest hold up with actually finishing the boat is the upholstery and the trim. The vinyl on the new seats is totally unavailable. There are several vinyls that are close, but nothing that is exactly the same.
    I have now accepted the fact that I am going to have to have the new seats recovered in order to have the cockpit look like it has been thought about and not literally thrown together. I think the end result will far outweigh the inconvenience and cost of recovering perfectly good seats...

    For the interior, I decided to go with the light grey backless carpet that we used in the Ventura for the ceiling and charcoal for the cabin sides and storage shelves. Lessons were learnt on the Ventura, so I made a quick MDF mold of the outline of the ceiling and used that to cut out the carpet:

    IMG_4147.jpg

    It worked really well. One piece, 2m wide and near 3m long, up in one go, no joins and no creases. Quite happy with it:
    IMG_4151.jpg IMG_4153.jpg IMG_4154.jpg IMG_4155.jpg

    Just need to get a bit more charcoal carpet to finish the main cabin, then lots more grey to do the transverse bunk room. That will be lots of fun!

    The whole process is made so much easier and cheaper by using a suction gun and spray contact purchased in bulk. It is wonderful that the carpet actually sticks and stays when put in place.
    Those stupidly expensive spray cans of contact are really not suitable for doing this type of work. They just do not go far enough and the cost would end up prohibitive.

    The soft covers (cushions) will be getting done soon. The piping is blue, and it just doesn't work. Needs to be black, which will (should), then tie the cockpit and the interior together.

    We'll see.
    Attached Images Attached Images

  3. #138
    Ausfish Addict Chimo's Avatar
    Join Date
    Jun 2006
    Location
    Gold Coast

    Re: Mustang 24 rebuild

    Really great job.
    What could go wrong.......................

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Join us