PDA

View Full Version : Fitting Mechanical Steering



cosmo
01-11-2004, 04:43 PM
Hey,

I currently have the old wire and pulley steering system(borrow from NOAH) on my 15 ft Mustang.
I want to fit a new mechanical steering system and was wondering if it is easy to do. Has any one else done it? Got any tips?

blaze
01-11-2004, 06:15 PM
Hi cosmo
Has your o/board got a hollow tilt tube (thats where the morse cable goes. If it has got that you will need to buy a transom type setup where the cable mounts to your transom.
As far as fitting, if you have a little mechanical aptatude you should handle the job
Probable cost you about $350 or there abouts
cheers
blaze
ps
someone on this board had one for sale recently, do a search