dnej
09-06-2005, 02:24 PM
Gidday,
On an external trim tilt system,housed on board, would a hose clip, on an aluminium boat, (made of what was stainless steel), set up electrolysis, that would make the hose it was holding, brittle, and then snap when bent?.
The rest are just as old, and are fine, its just this one that was clipped.
Seems to be a flexible hose, covered with reinforcing exterior.
I understand that these Can these be made up at a brake specialist place.
Any ideas
David
On an external trim tilt system,housed on board, would a hose clip, on an aluminium boat, (made of what was stainless steel), set up electrolysis, that would make the hose it was holding, brittle, and then snap when bent?.
The rest are just as old, and are fine, its just this one that was clipped.
Seems to be a flexible hose, covered with reinforcing exterior.
I understand that these Can these be made up at a brake specialist place.
Any ideas
David