suzygs1000
08-12-2006, 10:06 PM
Hi,
I recently launched a new boat. I fitted a 110 litre Bemuda fuel tank to it (transverse V shaped one)
Before the motor was fitted, I put 50 litres in it.
A new Suzy 140 was fitted complete with fuel guage, which then registered just above the empty mark.
Following water testing, I filled the tank. The guage moved to half full. I asked the mechanic who fitted the engine about it. He said I should have a play with bending the sender unit float. Is this the way to go, or is there some way of calibrating the sender unit that Bermuda fit?
If I do bend the float, what should I reseal the sender unit to the tank with? I know from past experience that I can't use silastic!
Hope someone has some advice.
thanks Dave Morgan.
I recently launched a new boat. I fitted a 110 litre Bemuda fuel tank to it (transverse V shaped one)
Before the motor was fitted, I put 50 litres in it.
A new Suzy 140 was fitted complete with fuel guage, which then registered just above the empty mark.
Following water testing, I filled the tank. The guage moved to half full. I asked the mechanic who fitted the engine about it. He said I should have a play with bending the sender unit float. Is this the way to go, or is there some way of calibrating the sender unit that Bermuda fit?
If I do bend the float, what should I reseal the sender unit to the tank with? I know from past experience that I can't use silastic!
Hope someone has some advice.
thanks Dave Morgan.