mick.j
13-04-2019, 04:55 PM
Hello team
i have a problem
I went to service the anode on the base of my about board.
The one that's about 20 cm long and bolts onto the base of the transom mount
by a bolt at either end.
I was fishing the next day
Now because of Murphy law one of the bolts snapped.
Due to brackets on the transom , getting to the said bolt to tap it out is near on impossible.
My question is this, and it may seem stupid to some but I just want to double check and stupids my middle name.
Can I just run a single holed anode on the side that doesn't have the snapped bolt ?
I would say say yes but I imagine because it's smaller I would just be replacing it quicker than the larger anode that is 20 cm long and travels full width of the transom m mount?
i have a problem
I went to service the anode on the base of my about board.
The one that's about 20 cm long and bolts onto the base of the transom mount
by a bolt at either end.
I was fishing the next day
Now because of Murphy law one of the bolts snapped.
Due to brackets on the transom , getting to the said bolt to tap it out is near on impossible.
My question is this, and it may seem stupid to some but I just want to double check and stupids my middle name.
Can I just run a single holed anode on the side that doesn't have the snapped bolt ?
I would say say yes but I imagine because it's smaller I would just be replacing it quicker than the larger anode that is 20 cm long and travels full width of the transom m mount?