Mark0
26-12-2016, 12:22 PM
In the boat I have just purchased the floor that's been rebuilt recently and in good shape but for some reason has had the section cut out where the bilge pump goes, possible as the opening there was to small for the pump.
So I need to seal the exposed edge of the marine ply, the rest is covered by fibreglass.
What's best to use ? a polyester resin and if so does it need the catalyst part ? As it's not a fibreglass repair as such.
Or would I look at using flow coat or something like that.
Also any idea what is easiest to get off the build up on engine clowning I scratched off a bit with my fingernail, is a mixture of water and vinegar the go and if so what ratio ?
Ta
Sent from my SM-G920I using Ausfish mobile app (http://r.tapatalk.com/byo?rid=91595)
http://uploads.tapatalk-cdn.com/20161226/426beca5dd697347a6134d46c1f6221a.jpg
So I need to seal the exposed edge of the marine ply, the rest is covered by fibreglass.
What's best to use ? a polyester resin and if so does it need the catalyst part ? As it's not a fibreglass repair as such.
Or would I look at using flow coat or something like that.
Also any idea what is easiest to get off the build up on engine clowning I scratched off a bit with my fingernail, is a mixture of water and vinegar the go and if so what ratio ?
Ta
Sent from my SM-G920I using Ausfish mobile app (http://r.tapatalk.com/byo?rid=91595)
http://uploads.tapatalk-cdn.com/20161226/426beca5dd697347a6134d46c1f6221a.jpg