View Full Version : What polish do I use
Daintreediver
03-08-2014, 03:20 PM
So I have had my boat at the Fibreglassers for a while and also at the boat shop getting motor serviced. After getting my boat back there are several scratches on the outboard cowling which are very noticeable, I'm not sure who did it but it's done now.
My question is what sort of cut and polish can I try to use to at least fix this a little bit? Do I just use the same stuff that you use on a car? What are outboard cowlings made out of I'm guessing some sort of plastic? Is there a special type of polish i should use on it?
Also while I'm at it I might give the rest of the motor a normal polish should I use the same fibreglass polish I use on the hull or just a normal car polish like turtle wax etc?
Thanks for any help
bonneville
03-08-2014, 04:40 PM
best ive used, woody's polish does a brilliant job, top product
bonneville
Daintreediver
03-08-2014, 05:48 PM
Is that a cut and polish for the scratches or a general polish for the rest of the motor you are talking about?
Seahorse
03-08-2014, 06:04 PM
Use juice qcut
bonneville
03-08-2014, 06:24 PM
they supply the hole range for fibreglass restoration !
google them up, find a local distributor.
a mate of mine owns a fibreglass shop, specialising in boat work, transom's floors, restoring hulls etc, that's all he uses.
seen the results he gets, amazing.
bonneville
battleon
03-08-2014, 07:18 PM
Blackended wrote a good article on polishing etc Worth a read.
http://www.ausfish.com.au/vforum/showthread.php?104589-Detailing-HOW-TO&highlight=blackend
Or this one is very good also
http://forums.sbo.sailboatowners.com/showthread.php?t=105832&highlight=maine+sail%2C+wax
Blackened
04-08-2014, 07:55 AM
G'day
Personally only Farecla for me, with a little menzerna thrown in (very high end german polish).
In reality you can use any good quality polish with a FINE abrasive, make sure you wash the outboard thoroughly beforehand, and follow up the polishing with a wax to lock all the good work in.
Dave.
Daintreediver
04-08-2014, 08:06 AM
Hi blackened I had a look at those websites all the different products are overwhelming and confusing. I have a cut and polish for our cars will I be safe to use this just on the small scratched areas of outboard? I will then use a standard polish to do the whole outboard? Basically I just want to know if my car cut and polish will damage cowling because it's plastic? And when you say FINE abrasive do you mean a fine cloth or what?
Thanks
Blackened
04-08-2014, 08:20 AM
G'day
Fine abrasive i mean a polish with a fine abrasive in it. Let the polish do the work not so the material you use.
I cannot comment on what you have specifically but if it's a reputable brand such as mothers, meguiars or 3m etc it'll be ok. To be sure in the exact product you use, try it in an out of the way place.
By the way, what motor is it? depending on the brand and year it could be plastic, fibreglass or even a type of paint.
Dave
Daintreediver
04-08-2014, 12:47 PM
Cheers mate it's a 2012 115 hp Yamaha 4 stroke
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.