BrisManny
06-12-2013, 08:26 PM
Hi all,
I think this got lost in the upgrade - sorry if it's a repost.
I have a 25hp 2cyl 1 carb Yamaha 25hp tiller. WOT on the handle seems to only be about 80-90% on the picture.
Looking at where the cable connects, it seems it's adjusted to stop before it rolls around to WOT.
Picture 1 below - at throttle off, note the 2 circled marks.
Picture 2 below - WOT, the little roller doesn't make it around to the second mark. Also there is still movement available at the carby.
Is this right? Should the throttle wind right around to the second mark?
http://www.mannbo.com/images/carby1.jpg
http://www.mannbo.com/images/carby2.jpg
Sorry for the out of focus second shot - was leaning over to twist the throttle.
Cheers,
Shane
I think this got lost in the upgrade - sorry if it's a repost.
I have a 25hp 2cyl 1 carb Yamaha 25hp tiller. WOT on the handle seems to only be about 80-90% on the picture.
Looking at where the cable connects, it seems it's adjusted to stop before it rolls around to WOT.
Picture 1 below - at throttle off, note the 2 circled marks.
Picture 2 below - WOT, the little roller doesn't make it around to the second mark. Also there is still movement available at the carby.
Is this right? Should the throttle wind right around to the second mark?
http://www.mannbo.com/images/carby1.jpg
http://www.mannbo.com/images/carby2.jpg
Sorry for the out of focus second shot - was leaning over to twist the throttle.
Cheers,
Shane