londee
30-11-2013, 05:57 PM
My shift shaft has fallen out when replacing the impeller in my Yamaha 8hp. This has happen to me before but some how I managed to get it back into the correct place again... not this time. I think a roll pin stopping it coming out too far has corroded. Any one had this problem before? is there a trick I don't know!!
Same as part 27 below:
98374
I think this corroded roll pin is responsible:
98375
:helpa:
Same as part 27 below:
98374
I think this corroded roll pin is responsible:
98375
:helpa: