View Full Version : Screw hole filler
Crunchy
17-10-2012, 09:09 PM
Need to fill some screw holes which will be re-drilled and self tapping screws inserted (a few too many on the built in esky / seat not biting in any longer and I need to take it off anyway so may as well fix)
What's the best material for this?
Should I drill them out a bit first to clean them up?
Thanks peoples
honda900
17-10-2012, 09:36 PM
Plasti bond, works well, then gel coat or flow coat.
Regards
Honda.
Crunchy
18-10-2012, 11:39 AM
Thanks honds, looks like might be the stuff...the holes are hidden so would I need to go over with flow coat to seal them?
honda900
18-10-2012, 12:02 PM
Crunchy,
assuming it is fibre glass? if it has wood in it, then I would hit it with some resin or gelcoat, if not and out of sight I probly wouldnt worry to much.
Regards
HOnda.
Crunchy
18-10-2012, 12:31 PM
just glass so I'll get stuck into that this W/E...thanks for you help
wayno60
18-10-2012, 05:42 PM
use a bigger screw....:)
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.