PDA

View Full Version : CNC Marine Boat Plans



No Excuses
06-02-2012, 12:55 PM
Hi Fellas, i'm looking at purchasing a set of plans for a plate boat from cnc marine in western australia. Has anyone had any dealings with these guys? Any feed back good or bad would be greatly appreciated.

kav1050
02-08-2012, 09:41 PM
Hi, did you end up getting a kit from CNC marine in the end? Bit late but i did and so far very happy with the kit. I have only just started the build but it has been very easy to get it together, so far.
Drawings are good, and the cut outs on the plate are spot on. Here is a link to some photos of my build so far. http://www.members.westnet.com.au/aussiecks/boat/


Regards
Kav.

No Excuses
26-12-2014, 10:05 AM
Gday Kav,bit of a late reply (I don't get on here often). So you pulled the trigger on a kit, good on you. I haven't bought a kit as yet as 2 years and 2 kids later the hand brake was pulled on pretty hard. I'm thinking about pursuing the idea again in the new year and the 5.35cc looks attractive. How have you found the ride of the hull, handling, ride comfort etc?

Cheers Aaron