Splash
02-04-2011, 07:34 PM
I am relocating the position of my steering helm up another 200mm.
TO do this, I am removing my existing helm and replacing it with a brand new helm.
But, I cannot remove this existing helm.
I have tried to drill some 3-4mm holes in the circular nut holding the helm - so that I can crack the nut and then the bezel will fall inside.
Clearance is an issue to drill these holes and the nut hardness is HARD.
I have managed to drill a couple of holes, but that's it.
I have tried to break it with the cold chisel/hammer - without luck.
Photos show this circular nut inside.
APologies for the picture quality - issues with lightng and camera quality.
Help???
SPlash
TO do this, I am removing my existing helm and replacing it with a brand new helm.
But, I cannot remove this existing helm.
I have tried to drill some 3-4mm holes in the circular nut holding the helm - so that I can crack the nut and then the bezel will fall inside.
Clearance is an issue to drill these holes and the nut hardness is HARD.
I have managed to drill a couple of holes, but that's it.
I have tried to break it with the cold chisel/hammer - without luck.
Photos show this circular nut inside.
APologies for the picture quality - issues with lightng and camera quality.
Help???
SPlash