View Full Version : 2008 etec
chris69
28-02-2010, 10:23 PM
I dont no what has happened to this motor but for a 2008 motor it should not look like this,:-X it looked as though it had a bit of a internal fire in the leg.
sleepygreg
28-02-2010, 10:54 PM
Looks more to me like it had some external disassembly!!!!!
dodgyone
28-02-2010, 11:01 PM
Pretty sure that the normal carbon build up under the cowl. Thats where the exhaust is.
Noelm
01-03-2010, 07:56 AM
I think it has been pulled to bits!
Blackened
01-03-2010, 07:57 AM
G'day
Another poor attempt to bash a certain brand or technology with little or no idea to back up the caims.
Dave
notsa
01-03-2010, 08:26 AM
Get to the point if there is one.
maimai
01-03-2010, 03:48 PM
Was this motor on the back of a polly craft boat?? i do recall reading something about .....E Tec...Polly...and fire some time ago on this forum, you may find it if you used the search button up the top
chris69
01-03-2010, 07:28 PM
I found out what happened to it while on the the boat being towed it was hit from behind and bent it ,i could only see a small ding in the stainless steel prop, you would think they just would of replaced the leg where it was bent and not left to rot for such a young motor.
stevej
02-03-2010, 05:27 PM
G'day
Another poor attempt to bash a certain brand or technology with little or no idea to back up the caims.
Dave
what else is the internet for ?
porn and bashing etecs
Jabba_
02-03-2010, 07:08 PM
what else is the internet for ?
porn and bashing etecs
And Polycraft...;D
stevej
02-03-2010, 07:43 PM
a serious etec question any of the smaller 25 30s getting about
havnt seen any myself but keen to see how they run
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.