View Full Version : Wide Sides for Tinny
keen_angler
27-07-2009, 10:29 AM
Just wondering is someone can point me in the right direction, I am looking at getting some wides sides done up for my tinny. Can anyone recommend someone that could do the job for me, and if anyone has gone through this exercise lately and knows an approx price to get this done.
Southside of Brisbane would be prefrable but have no problem taking it else where for the right job
It is for a 4.2 tinny.
Cheers
Chimo
27-07-2009, 10:48 AM
Talk to Phil
Cheers
Chimo
Nico.d.R
27-07-2009, 04:28 PM
I got mine done by the boat builder (mako/stessl) i think it was around $500 extra on top off the boat price . I got my tinny from karee marine so they should be able to put you on to some one if mako wont do it . You might have trouble finding some body to do it if its been in the salt water , a lot off welders i have spoken to wont weld ally or stainless if its been in the salt water , i dont see a problem if its been grinded back and cleaned up right before the welding is done .
nico
aussie_true_blue
29-07-2009, 04:29 PM
Try Sam at Performance Boats at Brendale he does a bit of mods for tinnies
or have a chat with madmackeral he may be able to help
cheers Bob
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.