View Full Version : Tilt/trim switch
Hey any experts...I need a replacement tilt/trim switch for my 1976 Evinrude 115 hp ,I am only asking for help because of its age,I am probably going to have a problem getting the same unit as I have now, but fingers crossed somebody can point me in the right direction.
Maximum
14-02-2009, 09:52 PM
The switch went on my '92 88HP evinrude. I remember having a bit of a look around and working out that I would have to stump up a couple of hundred for the whole control unit. I ended up spending about $4 on a generic rocker switch at Jaycar which is roughly the same diminsions. Looks a bit average as its installed with electricians tape, and probably not designed for salt water immersion, but I'm happy to spend another $4 when this one corrodes (and its lasted a couple of years so far....)
Mick
Thanks mick, will give it a go...Paul
finga
18-02-2009, 03:45 PM
Any pictures of it matey?
Maximum
19-02-2009, 09:43 PM
Will take a photo this w/e and (attempt to) post it.
Mick
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.