Df140

[seawasp6666]

Hello
Can any one tell me where about inside the cowling of a DF140 suzuki is the plug to hook up to for the nmea lead iwant see if the plug is female or male before i order my cable gps to motor thanks for any help

[leezor]

Check out http://store.brownspoint.com/detail.asp?product_id=990C0-88034. There is a link there to a PDF which will give you all the info you need.

Cheers,


Lee

[seawasp6666]

Hi Leezor thanks for the reply went there printed pic of the plugs two in total one round one sqarue i had a look under my cowling couldnt for the plugs in the motor any tip where about there located

[leezor]

Here is a pic of where it plugs in on the 225hp, not sure where the 140hp plug is located though, sorry.
The following link may also be of interest.

http://www.ausfish.com.au/vforum/showthread.php?t=109712&highlight=suzuki+nmea

Cheers,

Lee

[seawasp6666]

Thanks lezzor
Found it its just above the fuse box sqaure plug
Thanks for the reply

[julian1]

does anyone know if you can buy the NMEA interface in Oz now ? also will it intergrate with Navman NMEA connections/software (5600 tracker) ?


cheer's

Julian

[honda900]

Julian,

You can get the interface from trymax marine.


seawasp6666,

There is a big thread on this subject,

http://www.ausfish.com.au/vforum/showthread.php?t=127084&highlight=ep20


yes the interface is just above the fuse box. The plug is a yamaha gauge plug, (you would not belive how hard It was to find). Be warned the interface cable you buy will have the wrong connector on it, it will be the same as on the engine, (major stuff up by someone).

Browns point and several other guys have wired the interface directly into the dash, this disables your analogue gauges and can void your warranty, ( I spoke to Haines Direct).

Regards
Honda

[seawasp6666]

Hi Honda
The interface cable has a round plug on the end browns point marine have a short cable to convert the round to a small square one so i shouldnt have any problems
P.s I hope

[honda900]

seawasp6666,

Mate if you have a late model, 07 or 08 motor then thats when you have problems with the connector.

If your engine is an earlier model you do not need the cable from browns point the round connector supplied with the EP20 is all you need.

It's the cable from browns point that has the wrong plug on it, it is the same connector on the engine, instead you need a male version of the plug which you can get from a yamaha gauge harness.

Regards
Honda

[seawasp6666]

Hi Honda
Thanks for the reply ive read the thread
I looked at my motor yes its late 2007 and it has small sqaure male plug the one from browns point the adaptor is it male or female and do you no how long the interface cable is
Thanks Wasp