ovakil
17-08-2008, 06:54 PM
I have a coxcraft pantera,I saw another one down at John Crawford marine.
It had an extra bung hole front floor.In photo where blue lid is,I would like to fit one as well.
Second question,in photo where I have my bilge pump is on a second thin floor,on the other boat it had a large cutout & bilge pump sat on the bottom of hull,I would like to do the same.
As on the outside of my boat I have 2 bung holes,the higher one is level with the second floor & bottom one on bottom of hull.
Reason I would like to put bilge down lower is when I had speedo cable off(didn't know at time):-[ I had a heap of water in the bottom compartment & I wasn't able to pump an out.
Thanks for your help
PS Those small holes in bottom they were from my battery brackets I have just moved them to higher ground under back seat after reading about fuel & gas vapours
It had an extra bung hole front floor.In photo where blue lid is,I would like to fit one as well.
Second question,in photo where I have my bilge pump is on a second thin floor,on the other boat it had a large cutout & bilge pump sat on the bottom of hull,I would like to do the same.
As on the outside of my boat I have 2 bung holes,the higher one is level with the second floor & bottom one on bottom of hull.
Reason I would like to put bilge down lower is when I had speedo cable off(didn't know at time):-[ I had a heap of water in the bottom compartment & I wasn't able to pump an out.
Thanks for your help
PS Those small holes in bottom they were from my battery brackets I have just moved them to higher ground under back seat after reading about fuel & gas vapours