What would you pay for this boat?

[chuss]

4.5m plate alloy hull
4mm bottom and sides
self draining deck
Full pod (can take 50-80HP)
underfloor flotation
centre console
Brand new, never been on water
2.1m beam
unpainted, ready for fitout (no electrics fitted at all)

on brand new trailer

[peterbo3]

Nothing. NADA. Zip . Zero. Until I had taken it or a sistership on a seatrial. No seatrial.............no deal.

[FNQCairns]

What brand?

[Dean1]

Im not sure what your wanting to do with a boat of this size but check out hinchy's 4.6m raider cat in the boats for sale section. Great boat for these $$$ definatly worth consdering. Cheers, Deano.

[chuss]

i've been on a sea trial in a smaller version..
It's a proven hull design by John Kemp - Oceantech

[Gagga08]

A little difficult to price a boat without more information chuss. Pictures would help!

[goldfish]

price would depend on so many things including what you want it for, are you capable of fitting it out yourself (paying others to do it can be exie) how long it would take to get finished, plus lots of other things. but i would guess about 70% of new price.
ok thats my 2cents

[chuss]

The boat is completed, all is needed is to fit the motor and required electrics.
Motor rating is 50-80HP

I'd be fitting the electrics, lights, wiring, steering wheel and any other accessories. Motor mechanic would do the motor fitout.

Pictures attached.

[chuss]

there is no motor fitted.. i have to buy that... I've budget for the following:

Motor: 50HP Honda ($7-8K fitted)
Electrics: batteries x 2, wiring, gang panels, lights, radio $2K
Sanding, polishing: i'll do it myself, have all the parts, polish, already.
Misc: bow sprit, anchor, rope, safety gear, chains $1K

[1lastcast]

Don`t forget the steering , screen , rod holders carpet or something for the floor ? maybe a live well and rego for boat and trailer .

You should contact a dealer of this make or of a similar make to get a price on unpainet bare hull and trailer only i would be wanting to save a couple of thousand at least to make it worthwhile .

[pedrodepacus]

is there a fuel tank or anything in it , do you know wat it weighs hull only

[bushbeachboy]

Who did the build?

[bushbeachboy]

Have you seen the plans? Have you been able to do any measurements to check if the plans were followed? How do you know it holds water? Will the builder take it down and put it in the water for you, before you spend any money?

I must admit it looks good in the pics.

Good luck with it.

[bushbeachboy]

Where does the deck drain? I can't see any scuppers in the photos.

[chop69]

chuss,
check the trailer build quality as well. make sure it is rated to handle the weight of boat, motor, fuel etc.

[FNQCairns]

Well considering people pay around 18-20k (i think) for a bluefin of the same length with a 60 4 and fully fitted out (no electronics) and trailered. Yours would be worth an 5k extra to the same point??

Actually can you tell us?

cheers fnq

[Wahoo]

well i'll take a stab and say 10 - 12 k.... looks to be a nice tinny............Daz

[the gecko]

Yes, 8-12k is my call too. There was a similar length plate boat, new, no motor, sold in Caboolture last year. I tracked it on ebay and it went for 12k, but it was painted up better.

Andrew

[Wahoo]

well just had a look at fishers 4.3 @ $16500 hull only, so i would say the price would be up there also, so maybe a bit more than i said above.............................Daz

[bushbeachboy]

This boat is for sale on the Oceantech website:

http://oceantech.com.au/boats-for-sale

[Local_Guy]

i'd say $6 - $10k.

my boat is similar to what your looking at apart from the self draining floor. my package cost $17,5k

[marty+jojo]

Not sure what it is worth, but i reckon it would be way underpowered with a 50hp 4 banger, i'd get a 60hp at minimum.
Nice looking boat though.
Marty.

[disorderly]

well just had a look at fishers 4.3 @ $16500 hull only, so i would say the price would be up there also, so maybe a bit more than i said above.............................Daz

Yeah , but the Fisher 4.3 is way better,Daz...
'cause you can "run to the reef " with it ::)http://www.ausfish.com.au/vforum/../yabbfiles/Templates/Forum/default/wink.gif.(just ask them)http://www.ausfish.com.au/vforum/../yabbfiles/Templates/Forum/default/tongue.gif.

[Lovey80]

I agree with Marty, budget for the biggest donk that is allowed.


Cheers Chris

[Skusto]

take noe to that there is no underfloor fuel tank so thats a bit of a bummer!

[peterbo3]

$12100 GST inclusive is the price shown on the builders website.