View Full Version : Form ply
ovakil
02-08-2008, 04:27 PM
Are you able to apply flow coat to form ply?
I'm going to rip up carpet & put new lids over fuel tank as old one's are a bit bowed.
Cheers.
Horse
02-08-2008, 05:47 PM
I would give form ply a good rough up if I was going to try to put any polyester resin product on it. Flow coat by itself may crack and allow water through. Perhaps consider a light coat of mat and resin before hand and prime it with resin thinned 10% with Styrene monomer to key it in
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.