Alvey Reels Australia
Made in Australia - Sold to the World.

Rods for Alvey Reels

 

Alvey reels require rods which are correctly set up in order to attain maximum efficiency from your reel.

The following points must be noted when purchasing or making a rod to suit an Alvey reel.

  • Low winch fitting, about 15 to 20cm (6 to 8 inches) from the end of the rod
  • Most important feature, to avoid restricting the line coils when casting, your first runner must be half way up the rod. This should be a large guide with a 50mm (2 inch) diameter or a high mount guide with a 25mm (1 inch) diameter or larger.
  • An open runner, mainly used when storing the rod and reel. It can also be used when winding in the line without any or very little load as it helps centre line when winding in. An open runner is supplied with every reel, if you wish to have a rod made. It is not critical to have an open runner on the rod.

 

Copyright 2003
Graphics from this site can only be used on non-commercial websites, provided a link back to this site is provided.

Top of page